Print this page

Installation

Compact Remote Roller Shutter Garage Doors

Installation Pic.1
Installation Pic.2
Pilot drill tracks with 5mm drill bit. All the way
through. Approx every 400mm.
Drill face of track with 13mm drill bit.
WARNING! Do not drill all the way through.
   
Installation Pic.3 Installation Pic.4
Slide guides onto the end plates as shown Mark out and position the guides. Plumb sides
and top.
   
Installation Pic.5 Installation Pic.6
Fix the guides to the wall with appropriate
fixings.
Remove front cover and fix back box to wall
   
Installation Pic.7 Installation Pic.8
Fine tune the bottom limit so the autolocks
engage.
If fine tune is required see pic: 10,11,12,13 /
14,15,16,17,
Fit the white bungs and fit the cover
   
Installation Pic.10 Installation Pic.11
LEFT HAND MOTOR. 50nm MOTOR SETTINGS
(Octagonal Head)
Adjust WHITE limit CLOCKWISE to increase the travel of bottom limit.
LEFT HAND MOTOR. 50nm MOTOR SETTINGS
(Octagonal Head)
Adjust RED limit CLOCKWISE to increase the travel of top limit.
   
Installation Pic.12 Installation Pic.13
RIGHT HAND MOTOR. 50nm MOTOR SETTINGS
(Octagonal Head)
Adjust WHITE limit ANTI CLOCKWISE to increase the travel of the top limit
RIGHT HAND MOTOR. 50nm MOTOR SETTINGS
(Octagonal Head)
Adjust RED limit ANTI CLOCKWISE to increase the travel of the bottom limit.
   
Installation Pic.14 Installation Pic.15
LEFT HAND MOTOR. 100nm MOTOR SETTINGS
(Square Head)
Adjust WHITE limit ANTI CLOCKWISE to increase the travel of bottom limit.
LEFT HAND MOTOR. 100nm MOTOR SETTINGS
(Square Head)
Adjust RED limit ANTI CLOCKWISE to increase the travel of top limit.
   
Installation Pic.16 Installation Pic.17
RIGHT HAND MOTOR. 100nm MOTOR SETTINGS
(Square Head)
Adjust WHITE limit CLOCKWISE to increase the travel of the top limit.
RIGHT HAND MOTOR. 100nm MOTOR SETTINGS
(Square Head)
Adjust RED limit CLOCKWISE to increase the travel of the bottom limit.
   
Wiring Diagram  
Wiring Diagram  

ImpoRtant Notes

  1. In the interest of your safety and others, this door must be operated by users familiar with its operation.
  2. When operating the door do not place fingers near or in guides or another moving parts at any time.
  3. The person operating the door must have it in sight at any times during this operation particularity if is automatic operation.
  4. Do not permit children to play with the garage door or electrical controls.
  5. Do not attach any objects to , or make any modifications to the doors as this may cause damage and/or physical injury.
  6. Operate the door only when adjusted and free from obstruction.
  7. Should the door become difficult to operate or completely inoperable, call a technician. Repairs and adjustments should only be undertaken by qualified person.
  8. Every 6 months check a tighten and loose fixings.
  9. Periodically clean your door with warm water, allow to dry naturally. Do not use abrasive or caustic based cleaners. Bird droppings are caustic please remove upon detection.
  10. Your new garage door needs an annual service by a competent person to maintain the CE mark and warranty.